Look at depth, cover and the fish you can locate before choosing a lure. These are starting points, not a report of what is biting today. The lake-specific links below show the documented applications.
Choose it when: Fish are holding tight to cover or need a slower presentation.
Depth and cover: Grass, wood, docks, points and deeper bottom structure.
Typical target: Largemouth and other black bass.
First move: Texas rig through thick cover; finesse rig for clear or pressured water.
Switch if: Fish are spread out and a faster search bait will cover more water.
See the full guide →Choose it when: You can reach the fish with a lure that contacts rock or runs beside structure.
Depth and cover: Riprap, points, ledges and sparse vegetation; depth depends on lure.
Typical target: Bass and other fish chasing moving bait.
First move: Choose the diving range for the target, then test cast angle and contact.
Switch if: Dense grass or timber makes treble hooks repeatedly snag.
See the full guide →Choose it when: Wind, stained water or shallow cover favors a moving single-hook lure.
Depth and cover: Brush edges, timber, wind-blown banks and vegetation lanes.
Typical target: Primarily largemouth bass.
First move: Keep the blades turning near cover; slow down before upsizing.
Switch if: Clear, calm conditions call for a smaller or slower bait.
See the full guide →Choose it when: Fish are feeding toward the surface, especially in low light or shade.
Depth and cover: Surface over points, vegetation edges, grass mats or schooling fish.
Typical target: Bass and surface-feeding white, striped or hybrid bass.
First move: Use a walking bait in open water, frog over mats, or popper near cover.
Switch if: Fish stop rising; follow them deeper rather than forcing a surface lure.
See the full guide →Choose it when: Fish and forage are spread along offshore routes at a trackable depth.
Depth and cover: Open water, channel edges and suspended schools with a safe boat route.
Typical target: Striped, hybrid and white bass in documented fisheries.
First move: Set a repeatable pass; change lure depth before changing several variables.
Switch if: Traffic, shallow hazards or restricted water make the pass unsafe.
See the full guide →Choose it when: Electronics or a known target show fish stacked beneath the boat.
Depth and cover: Deep schools, bridge structure, humps and channel drops.
Typical target: White, striped and hybrid bass or crappie where documented.
First move: Keep the lure close to fish depth and lift it only as far as fish respond.
Switch if: Fish roam too quickly to keep the lure in their strike zone.
See the full guide →Choose it when: Crappie are holding near defined cover at a repeatable depth.
Depth and cover: Brush piles, bridge columns, timber and shallow spawning cover.
Typical target: Crappie.
First move: Hold a small jig or legal minnow just above the school.
Switch if: Fish relocate or bait transport rules rule out the planned live bait.
See the full guide →Choose it when: A legal natural presentation can be held close to fish without racing past.
Depth and cover: Suspended schools, brush edges or bottom structure.
Typical target: Crappie, striped/hybrid bass and some catfish.
First move: Match bait and hook size to the fish; check collection and transport rules.
Switch if: The bait cannot legally be carried, collected or used on that water.
See the full guide →Choose it when: Catfish are following forage near bottom or along a drifting route.
Depth and cover: Channel edges, flats, current seams and selected open-water drifts.
Typical target: Blue and channel catfish.
First move: Use legally sourced nongame bait and a rig that holds the desired depth.
Switch if: Your bait source is prohibited or the setup repeatedly snags.
See the full guide →